If you have purchased the closed-loop stepper motor version, please proceed with the configuration as shown in the screenshot below.

<aside> 💡

For the wiring sequence of the closed-loop stepper motor, please strictly follow the color coding shown above. You do not need to understand the corresponding wiring connections; simply adhere to the specified color order.

The corresponding order from top to bottom is:

Blue

Green

Yellow

Orange

Brown

Purple

Gray

Red

</aside>

In the materials you have purchased, there are two adapter boards. When using the closed-loop stepper motor, you need to insert these two adapter boards into the TMC driver sockets.

Please refer to the recommended installation method shown in the diagram below. This will facilitate identification.

For the wire colors on the two closed-loop stepper motor adapter boards, please refer to the diagram below.

<aside> 💡

Please note that the blue and green wires do not need to be connected.

</aside>

<aside> 💡

The wiring color sequence from left to right is:

yellow

orange

brown

purple

gray

red

</aside>